Pitched Roofs
Trapeze medium
The pre-drilled quick-mounting rail is suitable for upright mounting on trapezoidal sheets.
- Suitable for upright mounting
- High bead spacing: 207 mm to 333 mm
- Quick installation and pre-assembled middle and end clamps
- Higher yields due to improved rear ventilation of the modules
- Short delivery times and low freight costs
Technical Data
| Area of application | Pitched roofs with trapezoidal sheet metal or sandwich panels Roof pitch: 5 -60° |
| Roof connection / type of fastening | Thin sheet screw 6 × 25 mm, A2 bimetal Building authority approval: Z-14.1-4 RP-T2-6,0 |
| Module alignment | Vertical |
| Dimensions | L × W × H (mm): 400 × 26 × 35 |
| Material | Aluminium EN AW 6063 T66, EPDM |
| End and center clips | Height-adjustable and completely pre-assembled; clamping range 28-35 mm These are clicked directly onto the mounting rail; Adjust the middle and end clamps to the module frame height by turning the cylinder head screw (TX 40) and then fix in place; Tightening torque 8-10 Nm |
| Prerequisites | Sheet thicknesses: ≥ 0.5 mm steel or 0.7 mm aluminum Sandwich panels: Approval of the manufacturer required Bead width: At least 20 mm Flat support around the drill hole: Ø ≥ 20 mm Frame height of modules: 28-35 mm The clamping ranges of the modules must be checked before installation and compared with the bead spacing. The module manufacturer’s specifications must be observed and the maximum load-bearing capacity of the sheet metal must be checked. Each S Plus medium profile is screwed to the sheet metal with four thin sheet metal screws |
Project request
Please get in touch with us.
We will be happy to discuss the next steps with you.
